Cooper Menvier SD3 Manuale dell'Operatore Scaricare il pdf (Pagina 48)

Using the Remote Access Feature

The Remote Access feature can be used to record messages remotely,

listen into the property after an alarm message, and to toggle outputs to

turn on lighting etc. This facility is accessed by one of the following

methods:

Dial in for Remote Access

This method requires you to call into the SD2 in order to select the Remote

Access Menu. If the “Remote Option” is enabled (see page 23) you will

need to enter the Remote Access Code (see page 27). The unit is designed

to work on dedicated phone lines or shared lines by utilising the Answer

Phone Defeat feature (see below).

To Dial in for Remote Access (1 ring Answer OFF):

Dial the SD2 using a touch-tone telephone.

The SD2 will answer your call after the programmed number of rings (see

page 23).

You will hear a series of high-pitched beeps; at this point enter the

‘Remote Access Code’ on your telephone; you will hear an acceptance tone.

The Remote Access menu is now selected.

To Dial in for Remote Access (Answer Phone Defeat ON):

(Note: To enable this feature see “One Ring Answer” on page 24.)

Dial the SD2 using a touch-tone telephone.

Allow the telephone line to ring two or three times then hang up the call.

Wait approximately 10 seconds then redial the Speech Dialler.

The SD2 will answer your call after the first ring.

You will hear a series of high-pitched beeps; at this point enter the

‘Remote Access Code’ on your telephone; you will hear an acceptance tone.

The Remote Access Menu is now selected.

Acknowledgement and Selecting Remote Access

If the SD2 has been activated, the contact can, if programmed,

acknowledge the call and select the Remote Access mode (see next

section).

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 54 55 56

Nessun commento

Cooper Menvier SD3 Manuale dell'Operatore Pagina 48