Cooper Menvier SD3 Manuale dell'Operatore Scaricare il pdf (Pagina 45)

User Guide

Voice Message Calls

The SD2 requires a call acknowledgement in order to confirm that the

recipient has accepted the call. All contacts must be informed that to

accept a call they must press number 8 on their telephone. If a call is not

acknowledged by pressing 8, the SD2 will proceed to contact the next

programmed number.

How to Acknowledge a Voice Message:

When the telephone rings, answer the call as normal. Listen to the voice

message. The message is repeated 3 times in total.

When you have understood the message, acknowledge it at any time by

pressing the number 8 key on your telephone. You will hear an

acknowledgement tone from the SD2 and then the unit will hang up.

Now take the necessary action in response to the alarm.

Aborting the Call

If the SD2 is accidentally triggered or you want to stop the calling

sequence then one of the following methods can be used:

Entering the Operator’s Passcode

To abort the call sequence, enter your passcode. The display will show ‘Call

Aborted’.

Restoring the Trigger Input

To abort the call sequence, restore the trigger input back to its normal

condition. Normally this is a simple matter of resetting the alarm control

panel. The abort methods that can be used depend on how each trigger

input is configured, see page 23.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 55 56

Nessun commento

Cooper Menvier SD3 Manuale dell'Operatore Pagina 45